Notes:
- Default PIN code: 12345
Configuration:
- Perform Clean boot.
- Perform a Cold Boot by removing and re-installing the battery onto the RS507. The RS507 starts to operate using SSI mode.
Clean Boot:
Clean Boot restores the RS507 to its factory default configuration.
To perform a clean boot:
- Remove the battery from the RS507.
- Press and hold the Restore key.
- Install the Battery onto the RS507.
- Keep holding the Restore key pressed for about five seconds until a chirp is heard and the Scan LEDs flash green.
Security
Unpairing barcode
Use unpairing barcode to unpair the scanner and the device.
